Havis-Shields p-rear-1 w ユーザーズマニュアル

P-REAR-1^MFK-9_INST_9-07 

 

! 

 Read all instructions before installing any Havis-Shields Equipment Corp products.  
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! 
 Use hardware provided with install kit 

Power drill 
Drill bit set 

Standard socket set  
Ratcheting wrench 

 
COMPONENTS: 

 

   

 

 

 

 

1 Partition 

P-REAR-1 

   

 

1 

Mounting Filler Kit 

P-MFK-9 

 

   

 

 

 

 

1 

Passenger Side Filler Panel 

1 

Driver Side Filler Panel 

  

5 

¼” x 1 ½” Hex Head Lag bolts 

GSM33062 

2 

¼” x 3” Hex Head Lag bolts 

GSM33094 

•  Place and position partition with spring clips facing towards rear of vehicle. 

•  Bottom frame of partition will be approximately 8 ½” from edge of door Frame.  

•  Partition will contour trim just inside rear doors of vehicle. 
•  Drill 3/16” pilot holes into floor of vehicle. 

•  Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.  

•  Pre-drill top mounting holes with 3/16” bit.  Attach to vehicle using ¼” x 3” Hex head 

lag bolts. 

•  Tighten all loose hardware 

•  Install seat back to its original position

.