Havis-Shields c-3190 ユーザーズマニュアル

 

C 

C-3190_INST_9-07 

 

 

Step 3. Insert 2 (two) 1/4” x 1” hex 
head cap screws in shelf holes. 
Place bottom support bracket over 
hex head cap screws, then place 
hanger support bracket on top of 
bottom bracket. Place 2 (two) 1/4" 
flat washers and 2 (two) 1/4" flange 
nuts. 1998 Crown Vic: use pair of 
holes toward front of vehicle. For 
1997 Crown Vic: use holes toward 
rear of vehicle. 
 
Step 4. Using the support as a 
template, mark and drill two holes in
upper deck. Bolt support bracket on 
with 1/4” x 1” hex head cap screws, 

2 (two) 1/4” flat washers, and 1/4” 
flange nuts. Make sure shelf is 
level and tighten all hardware. 
 
Tools needed: 7/16” wrench and 
socket, drill and 1/4” bit, level. 
Hardware Included: 8 (eight) 1/4” 
x 1” screws, 8 (eight) 1/4” flange 
nuts, 8 (eight) 1/4” flat washers. 
 

 

Step 1. Align forward radio shelf 
bracket with existing holes in front 
of trunk wall. Use 2 (two) 1/4” x 1” 
hex head cap screws, 2 (two) 1/4” 
flat washers and 2 (two) 1/4” 
flange nuts. Don’t fully tighten 
bracket yet. 
 
Step 2. Use a block of wood or a 
shim to level radio shelf. Drill 1/4” 
hole into trunk hinge, support base 
on driver’s side. Fasten down shelf 
using 1 (one) 1/4” x 1” hex head 
cap screw, 1 (one) 1/4” flat 
washer, and 1 (one) 1/4” flange 
nut.