Uniden UBCT9 ユーザーズマニュアル

The UBCT9 can be conveniently mounted on a table, bulkhead, overhead, or any other
desired location with the supplied mounting bracket (refer to figure below for typical
mounting methods).
Caution:   Make sure there are no hidden electrical wires or other items behind the  

  

 

        desired location before proceeding. Check that free access for mounting and     

 

        cabling is available.

• Table top mount      

   • Bulkhead mount  

 

• Overhead mount

Before you mount the scanner, make sure you have all the necessary materials. Then
confirm that the scanner fits your vehicle’s mounting area. This unit requires a mounting
area of 50.8mm high by 176.5mm wide by 153.6mm deep.

Caution:  Be sure to avoid obstructions behind the mounting surface.

Follow these steps to mount the scanner in your vehicle.
1.   Choose a mounting location, then use the supplied
 

mounting bracket as a template to mark the positions

 

for the mounting screw holes.

2.   In the marked positions, drill holes slightly smaller
 

than the supplied screws.

3.   Attach the mounting bracket to the mounting location
 

using the supplied screws and lock washers.

4.   Attach the scanner to the mounting bracket using the
 

supplied mounting knobs.

5.   Connect the antenna’s cable to the ANT. connector
 

on the rear of the scanner.

Note:  If the antenna cable’s connector does not fit in
 

  the ANT connector, you might also need a

 

  Motorola-to BNC antenna plug adapter

 

  (available at a local electronics store).

UBCT9 OM   10

12/11/07   3:52:53 PM