Vulcan Materials vk series 1vk85c ユーザーズマニュアル

VK SERIES GAS FRYERS 

VULCAN-HART                                                                                                               F-32971 Rev. F (December  2011) 

-26-

 

 

Open the filtering drawer approximately 1” to allow any oil in the return line to run back into the filter 
pan.  This will take about 30 seconds to complete.  Then open the drawer completely to clean filter 
components. 
 
 

 
 

1.  Pull the filter drawer out and remove the crumb basket and empty any debris into the trash. 

 

2.  Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the 

insert by unlatching the latch.   Clean all parts thoroughly as mentioned in the Assembly 
section on page 19. 

 

3.  Scrape debris from the bottom of the filter pan and discard in the trash.  Clean all parts 

thoroughly as mentioned in the Assembly section on page 19. Clean all parts thoroughly as 
mentioned in the Assembly section on page 19. 

 

4.  Reassemble all filter components after being dried thoroughly as in the Assembly section on 

page 19. 

 
 

1.  Follow filtering instructions 1-3, however do not put oil treatment media into the fryer.   Drain 

the fryer oil into the filter pan.  

 

2.  Attach the quick disconnect hose to the discard male quick disconnect fitting, (hose not 

supplied with fryer – Accessory Option). 

 

3.  Place other end of the discard hose into a container that is large enough to retain the 

discarded shortening.  

 

4.  With the power switch still ON; press the discard/flush switch on.  Press and hold the filter 

button for at least 3 seconds and the Motor/Pump will begin to operate.  NOTE: Oil will come 
out immediately out of the nozzle end of the hose.   

 

5.  Once the oil has been discarded completely and the filter pan is empty, press the filter button 

to turn off the Motor/ Pump.  Then press the discard/flush switch off.  

 

6.  Disconnect the discard hose. The hose connection will be hot due to the temperature of the 

oil that was discarded.  Be careful to let the hose drain before putting away.  Close the drain 
valve and fill the fry tank with new oil.  

 

7.