Honeywell tradeline q314 ユーザーズマニュアル

2

1. Cut tubing to desired length and bend as necessary for

routing to pilot burner. Do not make sharp bends or deform
tubing. Do not bend tubing at control after compression nut
has been tightened, as this can result in gas leakage at
connection.

2. Square off and remove burrs from end of tubing.
3. Push tubing into compression nut clearance hole until

tubing bottoms.

NOTE: When replacing a pilot burner or orifice, cut off old

compression fitting and replace with new compression
fitting provided with new pilot burner. Never use old
compression fitting as it may not provide a gas-tight seal.
See Fig. 3.

4. While holding tubing all the way in, engage threads

and turn until finger tight.

5. Using a wrench, turn compression nut one turn beyond

finger tight. DO NOT OVERTIGHTEN.

6. Connect other end of tubing to gas control according to

gas control manufacturer instructions.

PILOT BURNER/
IGNITION-
SENSOR
JUST RIGHT

PILOT BURNER/
IGNITION-
SENSOR
TOO LOW

PILOT BURNER/
IGNITION-
SENSOR
TOO HIGH

MAIN BURNER 
FLAME WILL 
IMPINGE ON
IGNITION-
SENSOR

IGNITION 
FLAME WILL 
IMPINGE ON
MAIN BURNER

IGNITION 
FLAME JUST 
MISSES
MAIN BURNER

M3285

PILOT BURNER BODY 

TIGHTEN NUT ONE 
TURN BEYOND 
FINGER TIGHT

FITTING BREAKS OFF 
AND CLINCHES TUBING 
AS NUT IS TIGHTENED

TO GAS CONTROL

M3295

INSTALL THERMOCOUPLE OR THERMOPILE
PUSH-IN DESIGN

1. Insert thermocouple or thermopile tip into hole or

barrel provided beneath pilot burner. See Fig. 4.

2. Push in firmly until thermocouple or thermopile is

locked into place.

ATTACHMENT NUT DESIGN

1. Insert thermocouple or thermopile tip into hole or

barrel provided beneath pilot burner. See Figs. 4 and 5.

2. Engage attachment nut threads and tighten until ther-

mocouple or thermopile is locked into place.

PILOT BURNER
ASSEMBLY

THERMOCOUPLE
OR THERMOPILE

PUSH-IN
CLIP

M3286 

OPTIONAL
ATTACHMENT
NUT

1. Route bleed gas tubing from bleed tapping on gas

control to the pilot burner.

2. Push clip into place. See Fig. 6.
3. Insert bleed gas tubing until 3/8 inch [10 mm] of tubing

is above pilot burner bracket. Tip of bleed gas tubing must not
extend into pilot flame.

To convert mounting bracket from “B” mounting bracket

to “A” mounting bracket, install the “A” mounting bracket
adapter to the pilot burner mounting bracket. Then install
pilot burner to main burner.

SCREW-IN TYPE

THERMOCOUPLE

ATTACHMENT NUT

M3269

ADAPTER

PILOT BURNER
ASSEMBLY