Crestron clt-4hsw4 clx-4hsw4 ユーザーズマニュアル

 

CLT- & CLX-4HSW4 

NOTE:  Modules and terminal blocks must be installed 
into the lowest available spaces and continue toward the 
top of the enclosure. 

The Crestron



 4-Feed, 4-High Switch Terminal Block and 

Module (CLT-4HSW4 and CLX-4HSW4, respectively), 
are considered a single entity and must be used together. 
They ship separately to permit termination of the field 
wiring to the CLT-4HSW4 prior to installation of the 
CLX-4HSW4, as described in this guide. They can be 
mounted in any Crestron Automation Enclosure (CAEN-
Series Enclosures). The terminal block is designed to 
terminate four circuit feeds (LINE and NEUTRAL) and 
distribute the controlled circuits (LOAD) to the fixtures. 
The module connects to the terminal block and performs 
switching (non-dim) control of four incandescent, low 
voltage, neon, cold cathode, fluorescent, or HID lighting 
loads, or motor loads. The maximum load is 16 amps (1/2 
HP) for each controlled circuit (64 amps total per 
module). The unit requires 120VAC 60 Hz input voltage. 
An oversize heat sink dissipates heat efficiently. There are 
LEDs on the module to indicate communication to a 
Cresnet



 network, input power to the module, and output 

power to the load. 

MODULE

TERMINAL

BLOCK

GROUNDING

TERMINAL

BLOCK

 

 

This product is Listed to applicable UL Standards and 
requirements by Underwriters Laboratories Inc.  

     

(E103692)

 

GROUNDING TERMINAL BLOCKS

MODULE

TERMINAL BLOCK

(LEFT)

TERMINAL BLOCK

(RIGHT)

 

Terminal block and module must be mounted into a 
Crestron Automation Enclosure by a licensed electrician, 
in accordance with all national and local codes.  

CAUTION:  This equipment is for indoor use only and 
needs to be air-cooled. Mount in a well-ventilated area. 
The ambient temperature must be 32

°F to 104°F (0°C to 

40

°C). The relative humidity must be 0% to 90% (non-

condensing).  

Terminal blocks are installed along the left side of single-
wide enclosures and along the outside edges (left and 
right sides) of double-wide enclosures. Modules are 
installed along the right side of single-wide enclosures 
and side-by-side in the center of double-wide enclosures. 
When installing modules and terminal blocks in a double-
wide enclosure, be sure to invert units on the right side so 
that they can be properly wired. Refer to the illustrations 
shown in the next column when considering the location 
of terminal blocks and modules within an enclosure.  

 

 

15 Volvo Drive   Rockleigh, NJ 07647

 

Tel: 888.CRESTRON

 

Fax: 201.767.7576

Specifications subject to 

www.crestron.com

change without notice.