Namco Bandai Games 90500017 ユーザーズマニュアル
MOVING THE MACHINE
This machine is fitted with castors to make it easier to move. Take care when moving the machine on an
inclined surface.
inclined surface.
The Header Assembly has a forward centre of gravity, so it is important that at least two people are used to
fit or remove the Header Assembly.
The fitting position of the Header Assembly is high, and it is important that a means of reaching the height
safely,without stretching, is available. (e.g. Steps, Step Stool etc.)
safely,without stretching, is available. (e.g. Steps, Step Stool etc.)
The overall height of the machine, with the Header Assembly fitted, is 2310mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
When moving the game, ensure that the game is dis-assembled into 3 parts: Monitor Assy, Ride Assy and
Header Assy.
REMOVING AND REPLACING PARTS
Adjustments or maintenance on this machine should be carried out by suitably qualified personnel only.
Do not make any alteration to this machine without prior approval. Doing so could cause unforeseeable
danger.
Only parts specified by Namco Europe Ltd should be used when replacing or repairing parts. (Including
screws).
screws).
Ensure that the power to the machine is turned OFF before commencing any maintenance work. (Trouble
shooting, repairs etc.)
If performing work not described in this manual, be sure to contact your distributor for instructions, as no
responsibility will be accepted for damage or injury.
Parts of the Power Supply and Monitor remain hot and carry high voltage even after switching OFF and
could cause burns or electric shock. Take care not to touch these parts accidentally.
Make sure that the machine is switched OFF before connecting or disconnecting any plugs or connectors.
When removing the mains connector from the machine, or the mains plug from the wall outlet, always
grasp the plug and not the cable.
NOTES ON INSTALLATION
NEVER turn the power to the machine ON until installation has
been completed.
been completed.
In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
machine is connected to the mains with a securely connected
earthed plug.
So that customers are not injured by the movement of the machine,
ensure that there is as least 500mm separation between other
machines or walls.
ensure that there is as least 500mm separation between other
machines or walls.
In order to avoid damage to the machine due to mis-operation, ensure
that the voltage of the mains supply is 230volts AC.
Note: If the location of this machine has a polished floor, it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor.
machine sliding on the floor.
Note: In order to gain access to the Power Supply and CPU assemblies, make
sure that the rear of the machine is separated from a wall or other
machine by at least 500mm.
machine by at least 500mm.