Namco Bandai Games 90500017 ユーザーズマニュアル
Page 43
7.
Connect the connectors and air tube.
8.
Replace the joint cover removed in step 1.
Note:
The air tube is a push fit. Ensure that the tube is pushed fully in when
fitting.
When removing the air tube push the blue ring of the connector in and
whilst holding it in, pull the air tube out.
If the compressor reservoir tank has air in it, a loud noise will be heard
as the air escapes when the air tube is removed.
fitting.
When removing the air tube push the blue ring of the connector in and
whilst holding it in, pull the air tube out.
If the compressor reservoir tank has air in it, a loud noise will be heard
as the air escapes when the air tube is removed.
9.
When the machine is in its final position, lower the eight level adjusters,
(4 on the monitor cabinet and 4 on the ride assy), with a spanner so that
the machine is level and all castors are raised from the floor by approx.
5mm. Tighten the lock nuts with a spanner to ensure that the level
adjusters do not move.
(4 on the monitor cabinet and 4 on the ride assy), with a spanner so that
the machine is level and all castors are raised from the floor by approx.
5mm. Tighten the lock nuts with a spanner to ensure that the level
adjusters do not move.
Note: If the location site of this machine has a polished floor it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor when in use.
machine sliding on the floor when in use.