Dynex DX-ECDRW100 ユーザーズマニュアル

 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two conditions: 

1.  this device may not cause harmful interference, and 

2.  this device must accept any interference received, including interference that may 

cause undesired operation. 

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses and can emit radio frequency energy and, if not installed or used 
in accordance with the instructions, may cause interference to radio communications. 
However, television reception interference can be determined by turning the equipment off 
and on. The user is encouraged to correct the interference by one or more of the following 
measures: 

•  Reorient or relocate the receiving antenna 
•  Increase the separation between the equipment and the receiver 
•  Connect the equipment into an outlet different from that to which the receiver is 

connected 

•  Consult the dealer or an experienced radio/TV technician for help. 
 
 

Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment. 

“The drive is in conformity with the EMC directive and low-voltage directive.”