Fujifilm FinePix JV200 ユーザーズマニュアル

ページ / 114
vii
For Your Safety
•  Do not mix old and new batteries, batteries 
with diff erent charge levels, or batteries of 
diff erent types.
•  If the camera will not be used for an extend-
ed period, remove the batteries.  Note that 
the camera clock will be reset.
• The batteries may be warm to the touch 
immediately after use.  Turn the camera 
off  and allow the batteries to cool before 
handling.
• Battery capacity tends to decrease at low 
temperatures.  Keep spare batteries in a 
pocket or other warm place and exchange 
as necessary.  Cold batteries may recover 
some of their charge when warmed.
•  Fingerprints and other stains on the battery 
terminals can impair battery performance.  
Thoroughly clean the terminals with a 
soft, dry cloth before inserting them in the 
camera.
If the batteries leak, clean the battery 
compartment thoroughly before in-
serting new batteries.
If fl uid from the battery comes into 
contact with skin or clothing, fl ush 
the aff ected area with water.  If fl uid 
enters your eyes, immediately fl ush the 
aff ected area with water and seek 
medical attention.
  Do not rub your eyes.  
Failure to observe this precaution could 
result in permanent visual impairment
.
 
■ Ni-MH Batteries
The capacity of Ni-MH batteries may be 
temporarily reduced when new, after long 
periods of disuse, or if they are repeatedly 
recharged before being fully discharged.  This 
is normal and does not indicate a malfunc-
tion.  Capacity can be increased by repeatedly 
discharging the batteries using the discharge 
option in the camera setup menu and re-
charging them using a battery charger (sold 
separately).
 
CAUTION: Do not use the discharge option 
with alkaline batteries.
The camera draws a small amount of current 
even when off .  Ni-MH batteries that have 
been left in the camera for an extended pe-
riod may be drawn down to the point that 
they no longer hold a charge.  Battery perfor-
mance may also drop if the batteries are run 
down in a device such as a fl ashlight.  Use the 
discharge option in the camera setup menu 
to discharge Ni-MH batteries.  Batteries that 
no longer hold a charge even after repeat-
edly being discharged and recharged have 
reached the end of their service life and must 
be replaced.
Ni-MH batteries can be recharged in a bat-
tery charger (sold separately).  Batteries may 
become warm to the touch after charging.  
Refer to the instructions provided with the 
charger for more information.  Use the char-
ger with compatible batteries only.
Ni-MH batteries gradually lose their charge 
when not in use.
 
■ Disposal
Dispose of used batteries in accord with local 
regulations.
AC Power Adapters (Available Separately)
AC Power Adapters (Available Separately)
This section applies to all camera models.  
Use only FUJIFILM AC power adapters desig-
nated for use with this camera.  Other adapt-
ers could damage the camera.
•  The AC power adapter is for indoor use only.
• Be sure the DC plug is securely connected 
to the camera.
• Turn the camera off  before disconnecting 
the adapter.  Disconnect the adapter by the 
plug, not the cable.
•  Do not use with other devices.
•  Do not disassemble.
•  Do not expose to high heat and humidity.
•  Do not subject to strong physical shocks.
•  The adapter may hum or become hot to the 
touch during use.  This is normal.
• If the adapter causes radio interference, 
reorient or relocate the receiving antenna.