Vulcan Materials ml-114797 ユーザーズマニュアル
— 13 —
CONVEYOR BELT ASSEMBLING AND DISASSEMBLING (Fig. 8)
Install the conveyor belt so that it always runs in the
direction indicated by this arrow — the closed end of
the loop toward the direction of travel.
direction indicated by this arrow — the closed end of
the loop toward the direction of travel.
The arrows in the belt illustrate the movement of the
splicing strand between steps.
splicing strand between steps.
When bending the splicing strand, try to limit bending
to straight portions of the strand rather than in the "Z"
bend area.
to straight portions of the strand rather than in the "Z"
bend area.
Splice one side completely before starting the other
side.
side.
After completely splicing the belt, it is advisable to go
along the width of the belt straightening the spliced-
in strand.
along the width of the belt straightening the spliced-
in strand.
Depending upon the width of the belt, there might be
one, two, or three splicing strands.
one, two, or three splicing strands.
Fig. 8
2
3
4
5
6
7
1
PL-52997