Cub Cadet cub cadet lawn mower 769-05905 ユーザーズマニュアル

Remove the upper crating material from the shipping pallet, and 

cut any bands or tie straps securing the tractor to the pallet. 
Use the lift handle to raise the deck to its highest position. 

Engage the transmission bypass rods on each side of the 

tractor; then carefully roll the tractor off the shipping pallet. 

The transmission bypass rods (one for each the RH and LH 

transmission) are located beneath the frame platform, just inside 

each rear wheel. Disengage the bypass rods.  See Figure 1-1.

Remove the deck wash system nozzle adapter and oil drain tube 

from the manual bag and store for future use. Cut the wire tie 

holding the chute deflector up and discard any packing material.

To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan 

attached.
1. 

Cut any straps securing the seat assembly and the drive 

control levers to the tractor. Remove any packing material.

NOTE: Be careful not to cut the wiring harness connecting the 

seat and the seat switch in the bottom of the seat.

• 

One Lawn Tractor

• 

One Tractor Operator’s Manual

• 

One Deck Wash Hose Coupler 

• 

One Engine Operator’s Manual

2. 

Remove the two shoulder bolts, nuts and spacers securing 

the seat as shown in Figure 1-2.

3. 

Rotate the seat into position and secure the seat into place 

with the previously removed shoulder bolts, nuts and 

spacers. Be careful not to crimp or damage the wire harness 

while installing the seat. See Figure 1-3.