Cub Cadet cub cadet lawn mower gt 2000 ユーザーズマニュアル

3. 

Note which battery tray hole the RH side of the hold-down 

rod is hooked into.

4. 

Rotate the hold-down rod upward, over and around the 

battery to unhook from the battery tray.

5. 

Lift the battery out off the battery tray and remove from 

the tractor.

6. 

Position the new battery and lower into the battery tray.

7. 

Hook the hold-down rod into the previously noted battery 

tray hole, then rotate the rod around and over the battery.

8. 

Align the LH side of the hold-down rod with the hole in the 

battery tray and secure with hex screw remove earlier.

9. 

Connect the positive cable to the positive terminal of the 

battery, then connect the negative cable to the negative 

terminal.

Test and, if necessary, recharge the battery after the tractor has 

been stored for a period of time.
• 

A voltmeter or load tester should read 12.6 volts (DC) or 

higher across the battery terminals. See Figure 7-2.

12.7

100%

Full Charge

12.4

75%

90 Min.

12.2

50%

180 Min.

12.0

25%

280 Min.

• 

Charge the battery with a 12-volt battery charger at a 

MAXIMUM rate of 10 amps.

1. 

Overcharging

2. 

Undercharging

3. 

Loose and/or corroded connections

4. 

Excessive loads

5. 

Freezing of electrolyte

* These causes do not constitute warranty in the event of a 

battery failure.

Battery posts, terminals and related 

accessories contain lead and lead compounds. Wash 

Hands after handling.

When removing the battery, disconnect the battery cables in the 

following order to avoid arcing and the resulting sparks:
Battery Removal
1. 

Disconnect the Negative cable.

2. 

Disconnect the Positive cable.

When installing the battery, connect the battery cables in the 

following order:
Battery Installation
1. 

Connect the Positive cable.

2. 

Connect the Negative cable.

To replace the battery, proceed as follows:
1. 

Remove the negative cable from the negative terminal of the 

battery, then remove positive cable from the positive terminal.

2. 

Remove the hex screw securing the LH side of the hold 

down rod to the battery tray. See Figure 7-1.