Cadillac cts ユーザーズマニュアル
2-77
2. Press the Learn or Smart button on the garage
door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.
begin to flash when the motor head unit enters the
training mode.
Following this step, you have 30 seconds to
start Step 3.
start Step 3.
3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink button
three times.
three times.
The rolling
-
code garage door opener should now
recognize HomeLink. You may either use HomeLink or
the hand
the hand
-
held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
-
800
-
355
-
3515, or on
the internet at www.homelink.com.
Canadian Programming
Canadian Owners: During programming, the hand
-
held
transmitter may automatically stop transmitting after
two seconds. In this case, you should press and hold
the HomeLink button (see Steps 2 and 3 under
“Programming the HomeLink Transmitter”) while you
press and re
two seconds. In this case, you should press and hold
the HomeLink button (see Steps 2 and 3 under
“Programming the HomeLink Transmitter”) while you
press and re
-
press (cycle) your hand
-
held transmitter
every two seconds until HomeLink is trained.
Operating the HomeLink Transmitter
Press and hold the appropriate button on HomeLink for
at least half of a second. The indicator light will come
on while the signal is being transmitted.
at least half of a second. The indicator light will come
on while the signal is being transmitted.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.