Friedrich kuhl r-410a ユーザーズマニュアル

30

Remove the decorative front cover by using the tool 
provided (see fi gure below).

Tighten the four (4) captive screws as indicated by the 
arrows in the fi gure above before closing the front panel 
(do not over tighten)

. Ensure the fi lter is in place. 

Make sure curtains do not block the side air intake

 

Align the cord notch over the cord and center the fresh 
air lever. Align the cover over the User Interface 
(UI) to ensure it is clear around it and it does not 
depress any buttons. If not installed correctly the 
wrench alert symbol could fl ash.

Remove the decorative front cover. (See fi gure  at 
left). Remove the chassis Entrygard Retainer Wire by 
removing the screw at the front right bottom corner screw 
(See Figure below).  Save this screw for reattachment 
after reinstalling the chassis. 

Hold the cabinet stationary then use the hand grips on 
both ends of the control unit support bracket to pull the 
chassis out of the cabinet (see below).

Before reinserting the chassis into the sleeve ensure to 
properly reinstall the chassis seal gasket.

Disconnect power to the unit before 

servicing. Failure to follow this warning 

could result in serious injury or death. 

Disconnect power to the unit before 

servicing. Failure to follow this warning 

could result in serious injury or death.