briggs--stratton 5900681 ユーザーズマニュアル

The rollers on this Zero Turn unit are not intended to 
ride on the ground.  DO NOT adjust rollers to ride on 
the ground. Rollers riding on the ground will damage 
turf and/or unit.

 1.  First level the mower deck using the procedure 

found in MOWER DECK LEVELING.

 2.  With the mower installed, place the rider on a 

smooth, level surface such as a concrete floor. 
Turn the front wheels so they are straight.

 3.  Place the mower cutting height pin in the 4th hole 

from the bottom (C, Figure 40).

 4.  Measure the distance between the outside ends of 

the roller bar and the ground. If there is more than 
1/8” (3mm) difference between the measurements 
on each side, proceed to step 5.

 5.  Locate the roller bar leveling eccentric and 

locknuts (A, Figure 42).  Loosen the locknut and 
turn the eccentric to raise or lower a side.  When 
the correct level is achieved, hold the eccentric 
with a wrench and tighten the locknut.  Repeat 
step 4 if necessary.

Troubleshooting, Adjustments, & Service

 1.  Park the rider on a smooth, level surface such as 

a concrete floor.  Disengage the PTO, engage the 
parking brake, turn off the engine, and remove the 
ignition key.

 2.  Raise the mower deck to transport position.  

 1.  Pull the lever (A, Figure 43) towards the rear of 

the machine to release tension on the mower belt.  
Secure the lever in the guard notch (B).

 2.  Remove the old drive belt and install the new 

one as shown in Figure 44.  Note that the back 
of the drive belt must ride against the back-side 
idler pulleys (B).  Use the belt tension lever (A, 
Figure 44) to release tension on the idler pulley for 
installation.

Not 

for  

Reproduction