Cobra Electronics PR 1100 ユーザーズマニュアル

ENGLISH

ENGLISH

Channels 1-7 are shared with FRS/GMRS.
Channels 8-14 are FRS only. Channels15-22 
are GMRS only. (

IMPORTANT: See page 

19 for FRS/GMRS frequency allocations and
compatibility chart.)
1. With the radio on,

select any of the
22 channels by
pushing the
CHANNEL SELECT
button up or down. (

NOTE: Both radios

must be tuned to the same channel 
to communicate.)

CTCSS (Continuous Tone Coded Squelch
System) is an advanced tone coding system
allowing you to select one of 38 privacy
codes to reduce interference from other users
on the channel. (

NOTE: If you are using a

privacy code, both radios must be tuned to
the same channel and privacy code to
communicate. Each channel will remember 
the last privacy code you selected.)

1. After selecting a

main channel,
press and release
the MODE button.
A small number
will flash next to the channel in the LCD.

2. Push the CHANNEL SELECT button up 

or down to select a privacy code. You 
can hold the button up or down for 
fast advance.

3. When your desired privacy code 

is displayed, press and release the 
ENTER button.

To alert another person that you are calling:
1. Press and release the CALL button. The

other person will hear a 2-second ringing
tone. (See page 15 on how to select
between 10 call tone settings.)

You cannot send or receive transmissions
during the 2-second call tone.

1. Pull down the LOCK tab to remove the

battery compartment cover.

2. Insert four AAA batteries. (Always use 

high quality batteries.) Position batteries
according to polarity markings.

(

NOTE: See page 20 for information 

about optional battery pack, charger, and
additional accessories.)

1. Rotate the ON-OFF/VOLUME switch

clockwise to turn 
on the unit (and to
adjust the volume).
An audible tone 
will indicate the 
radio is on.

2. Your microTALK

®

is now in Standby mode,

ready to receive transmissions. The radio is
always in Standby mode except when the
TALK, CALL, or MODE buttons are pressed.

Battery power is indicated by the segments
appearing at the bottom of the LCD. As
battery power decreases, fewer segments 
will be visible. When BAT LO begins to 
flash, the batteries should be replaced. If 
you are using rechargeable batteries, they
should be recharged.

Your microTALK

®

radio has a unique circuit

designed to extend battery life. If there are 
no transmissions within 10 seconds, the unit
will automatically switch to Battery Save
mode and POWER SAVER will appear in the
display. This will not affect the unit’s ability to
receive incoming transmissions.

ON-OFF/VOLUME 

switch

Lock tab

CALL button

ENTER 

button

MODE

button

CHANNEL SELECT

button