Newcon Optik lam 3 ir ユーザーズマニュアル
7
High power mode is a health hazard!
Lock switch (15, Fig.2) with blocking ring (12, Fig.2) when
you do not intend using LAM in high power mode.
Use filter with the Red Channel in the training mode
LAM can be turned on either with a switch (13, Fig. 2) or
with a remote control pressure switch, when it is
connected through the remote control connector (16, Fig.
2). When the remote button is connected, switch (15, Fig.
2) only pre-selects modes, but does not activate them;
LAM goes on in the selected mode only while the remote
button is pressed. Connector (16, Fig. 2) should be
covered with the cap when it is not used. The remote
button can be attached to a rifle pivot or grip with
provided Velcro tape.
LAM has independent windage / elevation adjustment
mechanisms for aimers and illuminator channels. Knobs
(1, Fig. 1) adjust aimers channel, while knobs (2, Fig. 1)
and (17, Fig. 2) adjust illuminator channel. Rotation of the
adjustment knobs moves radiation spots on the target.
Directions of adjustment are marked on the knobs with
UP (beam moves up) and R (beam moves right).
When shooting with LAM, keep in mind that the ballistic
trajectory is a complicated curve, while laser beam is a
straight line, and these two lines cross in one or two
with a remote control pressure switch, when it is
connected through the remote control connector (16, Fig.
2). When the remote button is connected, switch (15, Fig.
2) only pre-selects modes, but does not activate them;
LAM goes on in the selected mode only while the remote
button is pressed. Connector (16, Fig. 2) should be
covered with the cap when it is not used. The remote
button can be attached to a rifle pivot or grip with
provided Velcro tape.
LAM has independent windage / elevation adjustment
mechanisms for aimers and illuminator channels. Knobs
(1, Fig. 1) adjust aimers channel, while knobs (2, Fig. 1)
and (17, Fig. 2) adjust illuminator channel. Rotation of the
adjustment knobs moves radiation spots on the target.
Directions of adjustment are marked on the knobs with
UP (beam moves up) and R (beam moves right).
When shooting with LAM, keep in mind that the ballistic
trajectory is a complicated curve, while laser beam is a
straight line, and these two lines cross in one or two