Konica Minolta micropress release 6 ユーザーズマニュアル

The following sections list various warning messages that may appear in the MP-RIP, RIP 

Monitor window, or Output Controller. 

Problems starting the MicroPress RIP

Network troubleshooting can be a difficult. Consult your network administrator for help.

MicroPress RIP failed on boot-up.

Error occurred during start-up.

Reset RIP to factory defaults.

MicroPress RIP startup failed.

Error occurred during start-up.

Reset RIP to factory defaults. Reboot the 

machine. If problem persists, re-install RIP.

Dongle not plugged in or invalid.
Fatal error: Fatal security device 
failure

Problem with dongle.

Check that the Sentinel device drivers have been 

installed and started. If problem persists, shut the 
MicroPress server down and restart. If problems 
persist, dongle may have failed or be invalid.

Could not access a resource 
for the current plug-in device 
driver.

Plug-in driver for the current 
device may have been moved.

Reset RIP to factory defaults.

Could not access a Setup 
resource.

Setup file is corrupted or 
missing.

Reset RIP to factory defaults.

There are no devices installed 
in the setup file.

No devices are installed in the 
Devices directory.

Re-install RIP.

Could not open the newly 
created MicroPress RIP setup 
file.

Too many other files open.

Close some files.

File too deeply buried inside. 
Move it somewhere else.

Filename is too long.

File to be accessed should be moved up in the file 
system to shorten the pathname.

Incompatible version of the 
MicroPress RIP setup file 
used/Old MicroPress RIP 
Setup file used.

Setup file being used is 
associated with a different 
version of software.

Find and install a copy of the correct setup file 
supplied with the RIP version running (this must be 
placed in the SW directory) or re-install RIP.

Problem finding file may be 
disk is damaged.

RIP cannot find a file.

Try running a disk repair utility, e.g., CHKDSK for 
NT.

Fatal AppleTalk Error. 
AppleTalk timeout.

Sending application took longer to send 
data than the timeout specified in 
AppleTalk Configure.

Verify network connections. If problem 
persists, increase the wait timeout.