Konica Minolta pi3505e ps driver ver1 ユーザーズマニュアル
Before Using the Printer Driver
1
Pi3505e/PS Printer Driver
1-9
1.5
Connecting the Machine to a Computer
Important!
Note the following precautions whenever turning off the machine.
Note the following precautions whenever turning off the machine.
G
Never turn off the machine when either of the following conditions
exists.
While the machine is performing some operation
While there is print data stored in machine memory (Turning off power
deletes data input from the computer.)
exists.
While the machine is performing some operation
While there is print data stored in machine memory (Turning off power
deletes data input from the computer.)
G
After turning the machine off, wait for at least about 10 seconds before
turning it back on again. Wait until the machine completes its power up
routine before trying to print.
turning it back on again. Wait until the machine completes its power up
routine before trying to print.
Connecting directly to a computer with an IEEE1284 cable
Available only if the Parallel Interface Kit is installed
1
Find the machine’s parallel port.
The parallel port is located on the left side of the machine.
2
Plug one end of the IEEE1284 cable into the machine’s parallel port.
3
Install a printer driver on your computer.
4
Connect the other end of the IEEE1284 cable to the computer’s
parallel port.
parallel port.
See the documentation that came with your computer for information
about where its parallel port is located.
about where its parallel port is located.