Vulcan Materials cem20u ml-138078 ユーザーズマニュアル

— 6 —

Each Combination Oven Stand is inspected
before leaving the factory. The transportation
company assumes full responsibility for safe
delivery upon acceptance of the shipment.

Immediately after delivery unpack and check
for shipping damage. If the stand is damaged,
save the packing material and contact the
carrier immediately. There is a fifteen-day
limitation on filing freight damage claims with
the freight company. Freight damage is not
covered under warranty.

NOTE:  Discard washers from kit.

Follow these procedures to properly assemble
the Adjustable Combination Oven Stand.

1. Remove the adjustable feet from the

bottom of the stand.

2. Using the 10 mm Allen wrench, loosen  but

do not remove the cap screw securing the
leg support to the stand base.

3. Push the leg onto the leg support and turn

the leg until the threaded holes are visible.
Insert the bolts and tighten them. Repeat
this step on each leg.

4. Once the legs are installed each leg must

be rotated so that the threaded holes, for
the tray support, face each other (front
and rear). These holes are used to mount
a tray support once the oven is installed on
the stand. The tray support will be installed
after the oven is installed on the stand. If
tray support is not used, insert the plastic
plugs into the four holes in the base.

FR

ONT

5. Tighten the Allen Cap screws in the base

of each leg.

6. Reattach the adjustable feet. The stand is

now ready for oven installation.