Honeywell B ユーザーズマニュアル

16

TP970 AND TP9600 SERIES PNEUMATIC THERMOSTATS

75-7134—1

O-RING

NOZZLE, THROTTLING PLATE 
AND BIMETAL ASSEMBLY

NOZZLE, 
THROTTLING 
PLATE AND 
BIMETAL 
ASSEMBLY

M12208

SCREW

SCREW

ANTIHUM 
SPRING 
OR CONE

SCREW

IF THERE IS NO ANTIHUM SPRING/CONE, THERE IS AN 
ADHESIVE PAPER DOT ON THE THROTTLING PLATE.

TYPICAL POST

SETPOINT CAM  
ASSEMBLY

TYPICAL 
PNEUMATIC 
ASSEMBLY

SPRING

1

1

When replacing these parts, use extreme caution to
prevent dirt, dust, or chips from entering various
chambers and openings of the thermostat.

1. Remove the four Phillips head screws which fasten the

restrictor block and filter (Fig. 19) to the back of the
thermostat.

2. Carefully remove the restrictor block assembly (plate,

restrictor, filter, gasket[s]).

3. Replace the restrictor block and filter.

Align the appropriate gasket over the
corresponding holes in the thermostat.

Insert the filter into the gasket until it bottoms.

Position the restrictor block.

Align the other gasket on the restrictor block.

Position the plate.

Replace screws and tighten.

GASKET

TYPICAL 
PNEUMATIC 
ASSEMBLY

FILTER

RESTRICTOR

GASKET

PLATE

SCREW

M12206