lift-master 65 6202 ユーザーズマニュアル

APPLICATION

Replaces operator hand chain wheel and chain with hook and
eyelet connection for extended floor level hand crank. Used on
Model H, DH and GH operators. Must be factory installed.

HAND CRANK MODIFICATION

Assembly Instructions

656202 OR 659201

(Models H & DH OR Model GH)

INSTRUCTIONS

1. A section of 1/2" rigid electrical conduit must be furnished by

the installer. The length of this pipe will vary with each
installation and should be determined so as to fix the winding
brace handle at chest height when connected to the door
operator.

2. Drill a 1/4" diameter hole through each end of the rigid pipe,

1/2" from the end.

3. Attach the eye and winding brace to the ends of the pipe with

the screws and nuts provided (Figure 2).

4. Connect the hand crank hook shaft in the same manner that the

eye is connected to the rigid pipe.

CRANK OPERATION

1. Pull the door operator disconnect chain down and lock in place

on the chain retaining bracket (Refer to operator owner’s
manual).

2. Slip the eye end of the hand crank over the hook on the

extended shaft of the operator and rotate the handle to
manually raise or lower the door (Figure 3).

Eye #3

1

Winding Brace #9

1

Hook #1

1

Eye

Hook

1/2" Pipe
(Not Provided)

Winding Brace

Eye

1/4" Screw

1/4" Nut

1/2" Pipe

Hand Crank
Hook Shaft

Disconnect
Chain