kvh 01027702bk install ユーザーズマニュアル
54-0350
3.5
Installing the Receiver
Prepare the Antenna Cable
The antenna cable should already be connected to the
antenna and routed to the receiver. If the cable is too
long, you may either coil the excess cable inside the
vehicle or cut the end of the cable to the desired
length. If you choose to cut the cable, use an LRC/
Augat T1000 crimp/strip tool to attach the supplied
Snap-N-Seal
antenna and routed to the receiver. If the cable is too
long, you may either coil the excess cable inside the
vehicle or cut the end of the cable to the desired
length. If you choose to cut the cable, use an LRC/
Augat T1000 crimp/strip tool to attach the supplied
Snap-N-Seal
®
F-connector to the end of the cable.
Since the antenna cable carries data, power, and
communications, the integrity of this cable and its
connections is very important.
communications, the integrity of this cable and its
connections is very important.
If you do not have an LRC/Augat T1000 tool (KVH P/N
19-0242), please order one from KVH at 401-847-3327.
19-0242), please order one from KVH at 401-847-3327.
Connect the Antenna Cable
Connect the antenna cable to the “To KVH Antenna”
jack on the receiver’s rear panel.
jack on the receiver’s rear panel.
Screw the connector
down securely.
Do not use a screw-on, push-on, or
twist-on connector. Low-quality connectors
will degrade system performance and
KVH’s warranty does not cover repairs
resulting from the use of such connectors.
twist-on connector. Low-quality connectors
will degrade system performance and
KVH’s warranty does not cover repairs
resulting from the use of such connectors.
Augat Tool
C AU T I O N
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
S -VIDEO
VIDEO AUDIO L AUDIO R
RF
REMOTE
INPUT
DIGITAL
AUDIO
OUT
TO
110W/HD
CONVERTER
TO KVH
ANTENNA
POWER (10-16V DC)
MAINTENANCE PORTS
USB
RS232
FUSE (8A)
Tested to comply
with FCC Standards
with FCC Standards
Antenna
Receiver
Vehicle Roof