kvh 01027702bk install ユーザーズマニュアル
f.
Loosen and remove the bolt, leaving the
jack nut secured to the roof.
jack nut secured to the roof.
Jack Nut Secured to Roof
7. Position the mounting blocks back onto the roof,
aligning their holes with the jack nuts.
8. Place the antenna onto the mounting blocks,
aligning the bracket holes with the mounting block
holes.
holes.
9. At each mounting hole, insert a
1
⁄
4
"-20 x 3
1
⁄
2
" hex
socket screw through the antenna bracket and
mounting block and into the jack nut. Tighten to
secure in place.
mounting block and into the jack nut. Tighten to
secure in place.
Securing the Antenna to the Roof
5
TracVision A7 Installation Guide – ADDENDUM
54-0350 Addendum to Rev. A
Bracket
Cover
Flat-head Screws
Mounting Block
Jack Nuts
WARNING
The mounting screws are prepared
with a thread-locking patch. If these
screws are removed after their
initial installation, the patch’s
locking capacity will be degraded.
Therefore, before reusing the
mounting screws, you MUST apply
threadlocker (Loctite 425) to the
screw threads to avoid a potentially
dangerous condition. Failure to
apply threadlocker to the screw
threads can result in unsecure
mounting.
with a thread-locking patch. If these
screws are removed after their
initial installation, the patch’s
locking capacity will be degraded.
Therefore, before reusing the
mounting screws, you MUST apply
threadlocker (Loctite 425) to the
screw threads to avoid a potentially
dangerous condition. Failure to
apply threadlocker to the screw
threads can result in unsecure
mounting.