hubbell-lighting sls-2 circuit ballast ユーザーズマニュアル

Catalog Logic:  R  E  M  D - X X X X  H  X - XX - XX

Fixture Watts:
1000

1500

1650

Fixture Voltage:
(2) 208v

(3) 240v

(4) 277v

(5) 480v

Circuit No. 1 & 2 Ballast Qty:
51 42 33 41 32 31 22 21 11
Optional Features:
(SH) Solution Harness Ready
(TB) **Thermal Magnetic Breaker
**Standard for 240v and below
(WP) Wood or other Solid Pole
(T) Wire Three Phase

A complete system includes the ballast enclosure, lighting
fixtures, wiring harness, crossarms and poles.

Warning!
• Dangerous voltages exist within this product.
• This enclosure includes two electrical supply circuits. To

reduce fire and shock hazards disconnect power to both
circuits before servicing.

• To reduce the risk of injury, operate and maintain to meet

all applicable codes.

• Installation is to be performed by a qualified electrician

only.

• Provide proper ground for all system components.
• Read and follow all instructions and labels before and dur-

ing installation.

• Failure to properly install this product will void

manufacturer’s warranty.

• Handle and secure so ballast enclosure cannot fall.
• Use protective equipment to avoid injury during installa-

tion of this heavy product.

• Do not route wiring through top of enclosure.

    This ballast enclosure should be installed at a minimum

height of 10 feet (3 meters) above grade.

Enclosure Installation (Figures 1, 2, & 3)
Important: Installation requires the use of a pole equipped
with mounting couplings and wireway. (Figure 1)
1. Remove peel strip from gasket supplied in hardware bag.
2. Apply gasket to the back of enclosure around the 2-1/2"

x 4-1/2" (63.5mm x 114.3mm) hole. (Figure 3)

3. Install bolt (2) and lockwasher (3) in the top coupling.

(Figure 2) Leave 1" (25.4mm) of thread exposed.

➞