Panasonic PT-L730NTE 操作ガイド

This should normally be set to ON.

ON
During automatic setup, the
projector selects whichever one of
the RGB1 IN or RGB2 IN
connectors has a signal being input,
and uses that signal for projection.
(If a picture is being projected, the
signal source is not automatically
changed.)

OFF
Use this setting when you do not
want the signal source to be
changed automatically during
automatic setup.

This setting is used to select the
function of the RGB2 IN/RGB1 OUT
connector. 

This sets the colour which is
projected onto the screen when no
signal is being input to the projector.

This setting should be changed in
accordance with the projector
setting-up method.
Set to “FRONT” when using a
normal reflective screen with the
projector positioned in front of the
screen, and set to “REAR” when
using a translucent screen with the
projector positioned behind the
screen.

This setting should be changed in
accordance with the projector
setting-up method.
Set to “DESK” when setting up the
projector on a desk or similar, and
set to “CEILING” when suspending

the projector from the ceiling using
the ceiling bracket which is sold
separately.

This setting changes the lamp
brightness. When set to “LOW”, the
luminance of the lamp is reduced, but
the projector uses less power, and
the operating noise is also reduced.
This can help to extend the lamp’s
operating life. If using the projector in
small rooms where high luminance is
not required, it is recommended that
you set the LAMP POWER to “LOW”.

This setting displays the usage time
for the lamp unit which is currently
being used. 

NOTE:
• The lamp’s operating life varies

depending on the usage conditions
(such as the LAMP POWER setting
and the number of times the power
is turned on and off). 

If using of this projector at high
elevations (above 1400 m), set the
FAN CONTROL to “HIGH”.