Panasonic HLCK644SBPQ 操作ガイド

37

•  Veneer or other finish of the furniture the appliance is being 

built into should be processed with heat-resistant glue 

(100°C); otherwise, high temperatures may cause them to 

deform.

•  Before installing the appliance, remove the back wall from 

the piece of kitchen furniture the appliance is being built 

into, along the entire length of the cutout. 

•  The installation cutout should be dimensioned as indicated 

in the figure. 

•  The bottom panel of the piece of kitchen furniture (Max. 

530 mm) should always be shorter than the side walls to 

enable adequate air circulation.

•  Level the piece of furniture the appliance was built into with 

a spirit level.

•  The piece of kitchen furniture the appliance is built into 

must be secured against movement, e.g. Attached to the 

adjacent pieces of kitchen furniture. 

•  Push the appliance into the kitchen furniture enough that 

the guides for the screws that are inserted in the oven 

frame holes are placed against the kitchen side walls.

•  When attaching the appliance, make sure the screws are 

not fastened too strongly as this may damage the furniture 

or the appliance enamel coating.

•  The appliance should be fitted with a device that disconnects it from all poles of the home 

network (an omnipolar switch), with at least 3 mm of distance between the contacts in 

open position. LS-switches or fuses are appropriate.

•  To connect the appliance, use the rubber mains cords (type HO5RR-F with the green/

yellow earth wire), PVC insulated (type HO5VV-F with the green/yellow earth wire), or 

other equivalent or superior cables. The cable must be rated at 16 Ampere or greater. The 

screw terminals can accept conductors between 1.5mm² and 6.0mm².

•  Veneer, glue, or plastic finish of the furniture next to which the cooker is installed, should 

be heat resistant (100°C). If the veneers are not high temperature resistant, they may be 

damaged.

•  Packaging (plastic foil, polystyrene, etc.) must be kept out of reach of children, as it can be 

a source or threat to them. Small parts can be swallowed by the children, and the foils are 

hazardous because of the risk of suffocation.

Important warnings

Installation