Panasonic DPMB545EU 操作ガイド

Power and ground connection
• Unplug this unit from the power outlets if it emits

smoke, an abnormal smell or makes unusual noise.
These conditions can cause fire or electric shock.
Confirm that the smoke has stopped and contact an
authorised service centre.

• Use only the power source marked on the unit. If you

are not sure of the type of power supplied to your
home, consult your retailer/dealer or local power
company.

• For safety purposes this unit is equipped with a

grounded plug. If you do not have this type of outlet,
please have one installed. Do not ignore this safety
feature by tampering with the plug.

• Do not place objects on the power cord. Install the

unit where no one can step or trip on the cord.

• Do not overload power outlets and extension cords.

This can result in the risk of fire or electric shock.

• Completely insert the AC adaptor/power plug into the

power outlet. Failure to do so may cause electric
shock and/or excessive heat resulting in a fire.

• Regularly remove any dust, etc. from the AC adaptor/

power plug by pulling it from the power outlet, then
wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a
fire.

• Never touch the plug with wet hands. There is a

danger of electric shock.

Installation
• Place the unit securely on a stable, level surface.

Serious damage and/or injury may result if the unit
falls.

• To prevent the risk of fire or electrical shock, do not

expose this product to rain or any type of moisture.

• Use this unit in a well ventilated area. Particularly, if

you will be using the unit for extended periods of time
or will be printing in large volumes, be sure to
ventilate the room sufficiently.

• Do not use this unit in places where the unit is

subject to direct air from air-conditioners, ventilators
etc. The inside of the unit may become too warm,
and cause the unit to deform.

Operating safeguards
• Turn the power OFF before cleaning. Do not use

liquid or aerosol cleaners.

• Do not cover slots and openings on the unit. They are

provided for ventilation and protection against
overheating. Never place the unit near radiators, or in
a place where proper ventilation is not provided.

• Never push any objects through slots in this unit. This

may result in the risk of fire or electric shock. Never
spill any liquid on the unit.

• To reduce the risk of electric shock, do not

disassemble this unit. Take the unit to an authorised
service centre when service is required. Opening or
removing covers may expose you to dangerous
voltage or other risks. Incorrect reassembly can
cause electric shock when the unit is subsequently
used.

• Follow all warnings and instructions marked on this

unit.

• Do not spill liquids (detergents, cleansers, etc.) onto

the telephone line cord plug, or allow it to become
wet at all. This may cause a fire. If the telephone line
cord plug becomes wet, immediately pull it from the
telephone wall jack, and do not use (fax supported
models only).

• Unplug this unit from power outlets and refer

servicing to an authorised service centre when any of
the following conditions occur:
– If the power cord is damaged or frayed.
– If the unit has been exposed to rain or water, or

liquid has been spilled into the unit. Do not use a
microwave oven to speed up the drying process of
any parts of the unit to avoid permanent damage.

– If the unit does not work normally by following the

operating instructions. Adjust only controls covered
by the operating instructions. Improper adjustment
may require extensive work by an authorised
service centre.

– If the unit has been dropped or physically

damaged.

– If the unit exhibits a distinct change in performance.

USB cable/LAN cable/USB memory
• To assure continued emission limit compliance:

– use only shielded Type-A male/Type-B male USB

cable (Example: Hi-Speed USB 2.0 certified cable).

– use only shielded LAN cable (supported models

only).

– use only USB memory that complies with EMC

standards (Example: CE, FCC) (supported models
only).

Wireless LAN (supported models only)
• Operating near 2.4 GHz electrical appliances may

cause interference. Move away from the electrical
appliances. This equipment must be installed and
operated in accordance with provided instructions
and a minimum 20 cm spacing must be provided
between antenna and all person's body (excluding
extremities of hands, wrist and feet) during wireless
modes of operation.

4