Panasonic ICX マニュアル
148
ICX (International), issued March/1999
ICX-35-700
Chapter 5. Key Telephone Features
Section 700 - Operation
To establish a two-party private conversation from a 3-party conference (Version 3.5
and higher):
and higher):
To remove a Busy Tone (Hang up) from an 8-party conference (Version 3.5 and
higher):
higher):
Hardware Requirements
•
A Conference Card (VB-44120) must be installed in the System in order to conference more than
three parties.
three parties.
Considerations
•
**If all the internal parties hang up, the conference call will be disconnected. If the internal party
remains in the conversation, the conference call remains in progress.
remains in the conversation, the conference call remains in progress.
•
When three parties are conferenced, a built-in 3-party conference circuit is used. If no 3-party
conference circuit is available, a conference cannot be established.
conference circuit is available, a conference cannot be established.
6. For 3-party Conference Call Only:
To release a conference member, press PROG + 1 to release
conference member 1 or press PROG + 2 to release confer-
ence member 2, etc.
conference member 1 or press PROG + 2 to release confer-
ence member 2, etc.
Note: The conference member numbers are shown on the
display.
display.
(Available up to 3-party conference. Not
available for 4-party or more conferenc-
ing)
available for 4-party or more conferenc-
ing)
7. To drop out of the conference call, hang up.
(See ** Consideration below)
Action
Result
1. While on a call, press the CONF + 1 (2) to have a private
conversation with the CNF 1 (2) party as shown on the dis-
play.
play.
You and the selected party are in a sepa-
rate conversation from the other confer-
ence parties.
rate conversation from the other confer-
ence parties.
2. To reestablish the conference, press CONF.
CNF1:CO XXX
or
EXT XXX
and
CNF2:CO YYY
or
EXT YYY
displays
(where XXX = first party and YYY = sec-
ond party)
ond party)
Action
Result
1. During an conference with more than 3 parties, press
CONF + (n) (where n is the number 1-7 for the conference
parties) to individually select a conference party.
parties) to individually select a conference party.
The other party is placed on hold.
2. If you did not select the conference party that is giving busy
tone, re-enter the conference by pressing the CONF key.
CONF Members: X
(where X = 4-7
party conference) displays
3. If you selected the conference party that is giving busy tone,
hang up and then go off-hook again and press the CONF
key to re-enter the conference call.
key to re-enter the conference call.
CONF Members: Y
(where Y = 4-6
party conference) displays
Action
Result