Panasonic th-152ux1 操作ガイド

Adjust the horizontal position.

Adjust the vertical position.

Adjust the horizontal size.

Adjust the vertical size.

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, 
adjust so that any such noise is minimized.

(During RGB and PC input signal)
Eliminate the fl ickering and distortion.

Over scan Turn image over scan On/Off.

Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 
1250 (1080) / 50i (RGB, DVI, SDI, HDMI)

            On                                 Off
Notes:
•  When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.
•  When the “Under scan” is set to “On”, this setting will be invalid.

(During RGB input signal)
Adjusts the clamp position when black parts of the image have no detail due to underexposure or are  
tinged with green.
Optimum value for Clamp Position adjustment
When black parts have no detail due to underexposure (blackout)
→ Value that causes least blackout is the optimum.
When black parts are tinged with green
→ Value that cancels the greenishness without causing blackout is the optimum.

Adjusts the image display size on screen.
Off:  Sets the normal image display size on screen.
On:  Sets the image display size approximately 95 % of the normal image display.

Notes:
• “Under scan” can be modified when “Studio mode” in the Options menu is “On”. When “Studio 

mode” is “Off”, this setting is “Off” and cannot be changed. (see page 43)

• This setting is valid only when the input signals are as follows;  

525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 
1125/30p, 1125/60p, 1125/50p, 1250/50i (RGB, DVI, SDI, HDMI)

• When “Under scan” is set to “On”, “H-Pos” and “V-Pos” in “Pos. /Size” can be adjusted. 
• Refer to each board’s operating instruction for DVI, SDI’s corresponding signals.