Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY 仕様ガイド

Installing and Upgrading Internal Modules in Cisco 2800 Series Routers

OL-5792-04

Installing and Removing DRAM DIMMs

Figure 15

Installing a DIMM

Step 4

Firmly press the DIMM into the socket until the spring-loaded clips on the socket snap over the end of
the DIMM.

Installing a DRAM DIMM in a Cisco 2811, Cisco 2821, or Cisco 2851 Router

To install a DRAM DIMM in a Cisco 2811, Cisco 2821, or Cisco 2851 router, follow these steps:

Step 1

Locate the DRAM DIMM connector on the system board. See

, depending on your router model, for the location of the DIMM connectors.

Step 2

Make sure that both latches on the DIMM connector are in the open position.

Step 3

Orient the DIMM so that the polarization notch lines up with the polarization key on the connector. See

Figure 12

Step 4

Insert the DIMM carefully into the connector.

Step 5

Carefully and firmly press the DRAM DIMM into the connector until the latches close onto the DIMM.
Make sure that both latches rotate to the closed position against the DIMM. See

Figure 16

DIMM

Insert and rotate into socket.

103154