SANUS VSF415 オーナーマニュアル

8

4.  Place the wall plate template 

 at your desired height and position the slotted holes over your stud center line. Level the wall plate 

template 

 and tape in place.

 NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.

: Be sure you mark and drill into the center of the stud.

5.  Drill the two pilot holes using a 5.5 mm (7/32 in.) diameter drill bit. 

: Pilot holes must be drilled to a depth of 75 mm (3 in.).

6.  Remove the wall plate template 

. Tighten lag bolts 

 only until the washers 

 are pulled fi rmly against the wall plate 

. 

 Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage Do not over-

tighten the lag bolts 

.

Fit lag bolt covers 

 over lag bolts 

.