BOSS BV960NV オーナーマニュアル
To connect and program 120ASWC1 to 104BV960N:
Connect appropriate power & ground leads as need for the radio and ASWC1.
Then …
Connect Brown wire of ASWC1 to KEY A wire.
Manually program the ASWC1 radio type as Jensen/Pioneer (6).
Go into the BOSS radio SWC programming menu and set SWC 3 as radio mode.
Program the desired buttons based on the functions list and buttons on the car.
IMPORTANT! This goes rapidly. One must hit the OK button immediately after the radio shows that it
learned the function.
Teaching each button from car to radio then has three steps:
Connect appropriate power & ground leads as need for the radio and ASWC1.
Then …
Connect Brown wire of ASWC1 to KEY A wire.
Manually program the ASWC1 radio type as Jensen/Pioneer (6).
Go into the BOSS radio SWC programming menu and set SWC 3 as radio mode.
Program the desired buttons based on the functions list and buttons on the car.
IMPORTANT! This goes rapidly. One must hit the OK button immediately after the radio shows that it
learned the function.
Teaching each button from car to radio then has three steps:
1.
Touch a function on the Boss screen from picture one. (example volume up)
2.
Press corresponding button on vehicle SWC controls
3.
Immediately press okay button on screen of Boss unit when the “Successful binding” message
appears.
Start again with selection of next button function and proceed with programming the rest of the
available buttons from vehicle wheel.
DO NOT HIT THE SWC (1.2.3) selection mode button again. (See bottom center of picture 1).
This clears the currently programmed functions.
Just hit the HOME button at upper left of the screen when done. Now test.