Kenwood DNX571TR オーナーマニュアル

18

  

ñ  

English

 

Ñ GPS antenna

GPS antenna is installed inside of the car. It should 
be installed as horizontally as possible to allow easy 
reception of the GPS satellite signals. 
To mount the GPS antenna inside your vehicle:

1)  Clean your dashboard or other surface.
2)  Remove the separator of the metal plate 

(accessory 

9).

3)  Press the metal plate (accessory 

9) down firmly 

on your dashboard or other mounting surface. 
You can bend the metal plate (accessory 

9) to 

conform to a curved surface, if necessary.

4)  Place the GPS antenna (accessory 

8) on top of 

the metal plate (accessory 

9).

9

8

 

✎

NOTE

•  Depending on the type of car, reception of the 

GPS satellite signals might not be possible with 
an inside installation.

•  Please install this GPS antenna in an area away 

from any antennas that are used with CB radios 
or satellite televisions.

•  The GPS antenna should be installed at a position 

that is spaced at least 12 inch (30 cm) from 
cellular phone or other transmitting antennas. 
Signals from the GPS satellite may be interfered 
with by these types of communication.

•  Painting the GPS antenna with (metallic) paint 

may cause a drop in performance.

 

Ñ Microphone unit

1)  Check the installation position of the 

microphone (accessory 

4).

2)  Clean the installation surface.
3)  Remove the separator of the microphone 

(accessory 

4), and stick the microphone to the 

place shown below.

4)  Wire the microphone cable up to the unit with it 

secured at several positions using tape or other 
desired method.

5)  Adjust the direction of the microphone 

(accessory 

4) to the driver.

4

Fix a cable with a commercial item of tape.