Brandmotion CRFD-8846 オーナーマニュアル

8846 Instructions 6-12-15

 .docx

 Page 

1 

of 

7 

 

Camera 
Chassis Harness 
Power Harness 
Mirror Harness 
Mirror with video display 
Zip lock bag with 15 Wire Ties & 3 Push Nuts 
Camera Extension Bracket 

These Instructions 

 

 

T15 & T20 Torx Bits 
7mm & 10mm Sockets 
Phillips Screwdriver 
3/8” Wrench or Socket Drive 
Plastic Trim Removal Tool 
Soldering Iron, Solder, & Heat Shrink Tubing 

(RECOMMENDED) or T-taps as an alternate 
splicing method 

Electrical Tape 
 

Step 1: Loosen lug nuts to remove spare tire. 

Step 2: Slide Camera on studs placing harness end 
inside of tire carrier. 

Step 3: Adjust Camera head to fit your specific wheel. 
Bracket is shipped in factory wheel configuration. 

 

 

Adjustment Bracket for Camera Clearance using Phillips 
Screwdriver and 3/8” Wrench or Socket Drive 

 

Note: Short Bracket has been designed for Factory 
offset wheels.  Use the Long Bracket for wheels with 
larger offsets.