JL Audio Stealthbox® オーナーマニュアル

S T E P   9
With a 10mm socket and ratchet, remove the four bolts that 
hold the factory woofer system into place. 

Unplug the amplifier and remove the woofer system out of 
vehicle.  

S T E P   1 1
Thread in the supplied socket cup set screw into the thread-
ed insert, located on the bottom of the Stealthbox®. 
Leaving 1/2-inch exposed. 

S T E P   1 0
After the factory woofer system has been removed, look 
down into the cavity. There is a rubber matting that lays on 
top of the wheel well. Cut the front half of this matting out.

Place the wax square to the proper measurements, 3" from 
the side wall and 5-1/4-inch from the front wall. 

Continued on Next Page 

SB-GM-HUMRH3/10W1v2_ 011215

S T E P   7
Remove the top panel.  

S T E P   6
With a Phillip® screw driver, remove the screw that is located 
under  the cover panel.  

With a T-50 torx bit and ratchet, remove the seat belt loop. 

S T E P   5
At the driver’s side rear door, remove the door sill. 

S T E P   4
From the cargo entrance, remove the weather stripping. 
Start at the lower middle. Pull off  just past the driver side 
paneling.  

S T E P   8
Remove the lower panel.

Page 2 • JL Audio, Inc 2005