Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル
QL-K2002
1983 - 1994 Ford Ranger/Bronco II
1994 Mazda Pickup
1994 Mazda Pickup
Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done!
Continued on other side:
FACTORY KICK PANEL REMOVAL:
DRIVER & Passenger Side:
SPEAKER INSTALLATION:
Q-FORMS KICKPANEL INSTALLATION:
After
Before
• Remove original threshold plate by removing attachment screws.
• Carefully pull kick panel away from bulkhead to release mounting clip.
• Tilt lower front edge upward and remove panel from vehicle.
• Carefully pull kick panel away from bulkhead to release mounting clip.
• Tilt lower front edge upward and remove panel from vehicle.
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A die
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A die
grinder or keyhole saw may also be used.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Install tweeters as per manufacturer’s instructions.
• Install the midrange speakers into the Q-Forms after they have been installed into the vehicle.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Install tweeters as per manufacturer’s instructions.
• Install the midrange speakers into the Q-Forms after they have been installed into the vehicle.
(Always predrill all mounting screw locations)
• Tilt tip of upper edge to allow it to slip under upper door seal molding.
• Rotate panel to position front edge tightly against rubber door seal.
• Rotate panel to position front edge tightly against rubber door seal.
Driver's Side:
Secure through upper rear mounting hole
below the e-brake with supplied 1" truss head screw.
Passenger's Side:
Secure through front edge mounting hole with
supplied 1 1/2" pan head screw and 1/2" white
nylon spacer.
nylon spacer.
Speaker Installation:
Lay the supplied polyfill in and around the
Q-forms cavity behind the speakers.
Secure speakers into locations. Be careful
to center speakers in mounting surface to
allow clearance for grill.
allow clearance for grill.
QL-K2004 Included Hardware:
(1) 1" Truss head screw
(1) 1 1/2" Pan head screw
(1) 1 1/2" Pan head screw
(1) 1/2" white nylon spacer
Estimated Installation Time: 2Hrs.