Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル

Remove Original Kick Panel

• Remove threshold plate by removing attachment screws.
• Remove screws securing original kick panel.

•  Cut the speaker holes into the Q-Forms before installing them into the vehicle.
•  Install the speakers into the Q-Forms after they have been installed into the vehicle.
•  Install speaker wiring and crossover network as per manufacturer’s instructions.
•  Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
   A die grinder or keyhole saw may also be used.
•  Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
•  Cut speaker mounting holes taking care as saw exits rear of panel.
•  Secure speakers into locations by driving screws through speaker bezel and into mounting

surface.  Be careful to center speakers in mounting surface to allow clearance for grill shell.

•  Install tweeters as per manufacturer’s instructions.

Install New Q-Forms Kick Panels  (Always predrill all mounting screw locations)

• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original
   kick panel. Be sure front edge of panel fits tightly against rubber door seal.
• Reinstall threshold plate using original screws. It may be helpful to hold panel

tightly against rubber door seal while tightening front screw.

• Install long screws and spacers through holes at upper edge of panel and drive into

holes held previously by original attachment screws.

• Install grill shells by pressing snugly into woofer cavity.

(4) 2-1/2" sheetmetal screws
(4) 1-3/4" spacers
(2) 1" sheet metal screws
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills

Estimated Installation Time: 1.5 Hrs.

QL-K3002

inst ver 43.1