Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル

Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done!

FACTORY KICKPANEL REMOVEL:   (Driver & Passenger sides)

Remove factory threshold panel by pulling upwards, releasing the snap clips.

Remove the factory kick panel by gently pulling the panel away from the sheet metal

releasing the factory clips.

Cut the speaker holes in the Q-Forms before installing the panels in the vehicle.

Using a hole saw of the correct size, position the pilot drill on the dimple at the

center of the speaker-mounting surface.  Be careful as the hole saw exits the

rear of the panel.  Install speaker wiring and crossover network as per

manufacture’s instructions.  Install tweeters as per manufacturer’s instructions.

Install midrange drivers after Q-Forms panels have been installed in the vehicle.

KICKPANEL INSTALLATION:  Driver's Side:

Slide the top edge of the kickpanel under the door gasket and slide up between

dash and gasket.  Rotate the kickpanel forward and over the hood release.  Pull

the hood release forward and slide the kickpanel around the hood release lever.

Push the kickpanel back until the edge of the kickpanel is behind the door

gasket. Pull the kickpanel forward, allowing the door gasket to capture the

kickpanel’s edge. Re-install the threshold panel.  Push down on the kickpanel to

ensure proper hood release alignment.  Secure the kick panel using the supplied

#8 x 3\4” screw. Lay the supplied Polyfill in the kick panel cavity. Install the driver

per manufacturer’s instructions. Be sure to center the driver for adequate grill

clearance.

Supplied Hardware:
2 - Color matched Grills
2 - #8 x 3/4" Sheet Metal Screws
2 - Polyfill Batting
1 - Foam Tape Roll
40" - "U"-channel