Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル

• Remove threshold plate by carefully prying up along bottom edge.
• Pull kick panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel out of vehicle.
• Remove dead pedal by unscrewing the plastic 1/4 turn fasteners.

• PASSENGER SIDE: (Only a few Accords will require this process.)
• Detach computer module by removing (3) mounting bolts.
• Pull up passenger floor board carpet pad.
• Detach metal floor pan located beneath the carpet by removing mounting bolts.
• Detach and shift computer module(s) as far left as possible.
• Relocate the computer module previously located in the kick panel to the newly created location below the

passenger floor pan.

• Securely fasten all computer modules with bolts previously removed.
• Reinstall metal floor pan, carpet pad and carpet back to the original position.

•  Cut the speaker holes into the Q-Forms before installing them into the vehicle.
•  Install the speakers into the Q-Forms after they have been installed into the vehicle.
•  Install speaker wiring and crossover network as per manufacturer’s instructions.
•  Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
   A die grinder or keyhole saw may also be used.
•  Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
•  Cut speaker mounting holes taking care as saw exits rear of panel.
•  Secure speakers into locations by driving screws through speaker bezel and into

 mounting surface.
 Be careful to center speakers in mounting surface to allow clearance for grill shell.

•  Install tweeters as per manufacturer’s instructions.

• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original kick panel.

Be sure front edge of panel fits tightly against rubber door seal.

• Reinstall threshold plate by pushing clips into original slots.
• Secure driver's side with sheet metal screw and spacer provided.
• On passenger's side secure at upper front edge and in web between

speakers at lower edge using 1" sheet metal screws provided.  It may be
helpful to predrill screw pilot holes if  installed without power tools.

• Install small cup shaped covers in holes in carpet and secure with supplied

fasteners.

• Install grill shells by pressing snugly into woofer cavity.

(4) 2-1/2" sheet metal screws
(4) 1-3/4" plastic spacers
(2) 1" sheet metal screws
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills

inst ver 54.1