Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル

Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done!

DRIVER Side:

PASSENGER Side:

Remove the threshold panel along the bottom of the front door opening by gently pulling upward to

release the snap clips.  Remove the plastic nut located at the top of the kick panel and save for

reinstallation later.  Gently pull the kick panel away from the metal bulkhead to release the snap

clips attaching it.  Relocate the small black module to the alternate mounting location approximately

3” higher and 2.5” forward on the metal bulkhead.

Remove the threshold panel along the bottom of the front door opening by gently pulling upward to

release the snap clips.  Remove the plastic nut located at the top of the kick panel and save for

reinstallation later.  Gently pull the kick panel away from the metal bulkhead to release the snap

clips attaching it.

Cut the speaker holes in the Q-Forms before installing the panels in the vehicle.  Using a hole saw

of the correct size, position the pilot drill on the dimple at the center of the speaker mounting

surface.  Be careful as the hole saw exits the rear of the panel.  Install speaker wiring and crossover

network as per manufacturer’s instructions.  Install tweeters as per manufacturer’s instructions.

Install midrange drivers after Q-Forms panels have been installed in the vehicle.

DRIVER’S Side:

Lay the Q-Forms kick panel into place in the approximate location and connect the speaker wiring.

Install the kick panel into the position previously held by the original kick panel.  Be sure that the

front edge of the panel fits tightly against the rubber door seal.  Also make sure that the hole toward

the back of the Q-Forms panel slides over the metal stud just like the factory panel did.  Install the

factory plastic nut over the metal stud and tighten.  Re-install the factory threshold panel along the

bottom of the door opening.  Slide the threshold panel tightly against the bottom edge of the Q-

forms panel and snap back into place.  Lay the supplied polyfill in and around the opening for the

midrange driver.  Install the midrange driver as per manufacturer’s instructions.  Be sure to center

driver in opening to allow clearance for the speaker grill.

Supplied Hardware:

  2  -  6” x 8” Polyfill Pad

  2  -  Color matched speaker grill

  1  -  Foam tape roll

40” -  Rubber U-channel