Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル

• Position new kick panel against original panel and check fit and parking brake function.
• Remove all fasteners from original kick panels. On driver's side remove hood release lever. On passenger's side

remove fresh air duct cover (cup shaped part at upper rear of panel.)

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.  A die grinder or
  keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface. Be careful to center
  speakers in mounting surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s
  instructions.

• Lay Q-forms kick panel in approximate

location and connect speaker wiring.

• Install panel into permanent position on top

of original kick panel. Be sure front edge of
panel fits tightly against original kick panel.

• Using original hardware where possible,

attach new kick panels through original
panel into metal bulkhead. Be sure to
reattach hood release lever and fresh air duct cover at this time.

• Install grill shells by pressing snugly into woofer cavity.

(4)  1" Screws
(2)  6" x 8" polyfill pieces
(2)  6.25" Q-grills

inst ver 28.1