Q-Logic Q-Forms Kick Panel Enclosures オーナーマニュアル
Monte Carlo/El Camino/Regal/Cutlass 78-87
QL-K1011
Remove Original Kick Panel
• Remove threshold plate by removing attachment screws.
• Pull kick panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel out of vehicle.
• Pull kick panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel out of vehicle.
Modify Parking Brake Pedal
• Using two crescent wrenches, carefully bend brake pedal arm so that pedal pad is relocated
approximately 1.5 inches to the right.
• Vehicles equipped with engine computer in the passenger side kick panel will need ro relocate it under
the passenger floor board carpet using the plastic housing provided.
NOTE: Always check the fit of the Q-forms into the vehicle before any cutting or modifications are done.
Install Speakers
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A die
grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-Forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A die
grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-Forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface.
Be careful to center speakers in mounting surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.
Install New Q-Forms Kick Panels (Always predrill all mounting screw locations)
• Lay Q-Forms kick panel in approximate location and connect speaker wiring.
• Install welt material provided onto exposed metal edge extending vertically from windshield molding to
• Install welt material provided onto exposed metal edge extending vertically from windshield molding to
threshold plate.
• Install panel into permanent position previously held by original kick panel. Be sure front edge of q-forms
panel fits tightly against rubber welt.
• Reinstall threshold plate using original screws. It may be helpful to hold q-foms panel tightly against rubber
welt while tightening front screw.
• Install long screw through hole at rear of Q-Foms panel and drive into inner bulkhead sheet metal. It
may be helpful to predrill screw pilot hole if installed without power tools.
• Install grill shells by pressing snugly into woofer cavity.
QL-K1011 Included Hardware:
(2) 1" Sheet Metal Screws
(1) Plastic computer housing
(2) 13" Rubber welt sections
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
(1) Plastic computer housing
(2) 13" Rubber welt sections
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
Estimated Installation Time: 2.5 Hrs.
inst ver 31.1