Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. TEAC
  4. UD-503
  5. オーナーマニュアル

TEAC UD-503 オーナーマニュアル

ダウンロード
ページ / 29
14
Display
When on
  WELCOME
c
  TEAC
  UD-503
After the above messages appear, the input source will be shown on 
the display.
Input source information display
The input source information display will appear after turning the 
unit on as well as when about 10 seconds pass without operation 
when a setting screen is open.
Display example
When headphones are not connected and LINE OUT LEVEL is 
set to FIX or OFF
USB   ORG DF OFF
     PCM 44.1kHz
Input source name
Audio data  
processing method
Digital filter setting
Input signal status
 
o
Turning the VOLUME knob will not change the volume.
When headphones are connected or LINE OUT LEVEL is set to 
VARIABLE
USB   ORG DF OFF
PCM 44k  -41.5dB
Input signal status
Volume
 
o
Turning the VOLUME knob will change the volume, and the vol-
ume will appear to the right of the input signal status.
Input source name
This shows the name of the selected source.
The names shown on the display correspond to the selected con-
nectors as follows.
USB
USB port
COAXf
Coaxial connection with the digital audio input (OPT/COAX IN) 
on the front panel
COAX
RCA COAXIAL digital audio input connector on the rear panel
OPTf
Optical connection with the digital audio input (OPT/COAX IN) 
on the front panel
OPT
OPTICAL digital audio input connector on the rear panel
LINE
Analog audio input connectors (LINE IN) on the rear panel
Audio data processing methods
ORG
The original input signal is sent directly to the D/A converter 
without upconversion.
2Fs
4Fs
8Fs
DSD
The upconversion shown will be used (page 18).
DoP
DSD signal is received by DoP (DSD over PCM) method.
Digital filter setting
This shows the digital filter setting (page 18).