Netgear AC1200 オーナーマニュアル



Select ADVANCED > Setup > LAN Setup.

Enter the settings that you want to customize. 

These settings are described in the following section, 

.

Click the Apply button.

Your changes are saved.

IP Address. The LAN IP address of the router.

IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP address, the 
IP subnet mask allows a device to know which other addresses are local to it, and which 
have to be reached through a gateway or router.

RIP Direction. Router Information Protocol (RIP) allows a router to exchange routing 
information with other routers. This setting controls how the router sends and receives 
RIP packets. Both is the default setting. With the Both or Out Only setting, the router 
broadcasts its routing table periodically. With the Both or In Only setting, the router 
incorporates the RIP information that it receives.

RIP Version. This setting controls the format and the broadcasting method of the RIP 
packets that the router sends. It recognizes both formats when receiving. By default, the 
RIP function is disabled. 

RIP-1 is universally supported. It is adequate for most networks, unless you have an 
unusual network setup. 

RIP-2 carries more information. Both RIP-2B and RIP-2M send the routing data in 
RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.