Tascam DR-44WL オーナーマニュアル
TASCAM DR-44WL
13
3 – Preparation
you purchased the unit or a TEAC service center to request
repair.
Using an external battery pack (sold
separately)
Connect a TASCAM BP-6AA external battery pack (designed for
use with this unit and sold separately) to the recorder with the
included USB cable as shown in the illustration. For details, see
the BP-6AA Owner’s Manual.
TASCAM BP-6AA (sold separately)
micro-B USB plug
Connect the
supplied USB cable
CAUTION
The DR-44WL cannot detect the remaining battery charge
of a BP-6AA. If you use a BP-6AA to operate the DR-44WL
without batteries in the recorder itself, the unit might stop
operating suddenly if the battery pack runs out of charge.
In order to avoid problems, put batteries with sufficient
In order to avoid problems, put batteries with sufficient
charge into the DR-44WL before connecting and using a
BP-6AA.
Using USB bus power
Use the supplied USB cable to connect the unit and the
computer as illustrated below.
micro-B USB plug
Computer
USB
When you connect a USB cable while the unit power is on,
or turn on the power after making a connection, the
USB
SELECT
screen will pop up, prompting the user to select
either to operate the unit with USB bus power or make a USB
connection with the computer.
Use the wheel to select
BUS
POWER
(highlighted) and press
the ENTER/MARK button to select power supply from the USB
port. The Home screen will appear.
NOTE
Power is supplied from the USB port when USB cable is
connected to the unit inserted with batteries (USB bus
power prioritized).
CAUTION
• Depending on the USB bus power specifications of the
computer, the DR-44WL may not operate with a USB
connection. If this occurs, use the dedicated AC adapter
(GPE053B) supplied with the unit instead.
• This unit is not compatible with the computer's power-save
mode or sleep-mode. Please turn off these modes when
operating the unit from the computer's USB bus power.
Turning the power on and off (standby
mode)
CAUTION
• When you turn the power switch off while supplying power
from the dedicated AC adapter (GPE053B) included with the
unit or the USB bus power connected to a computer, the unit
will go into standby mode.
• Before turning the power switch on and off, turn the volume
down for the sound system connected to the unit.
• Do not wear headphones when turning the power switch
on and off (standby mode); the noise may cause damage to
your ears and/or headphones.
Starting up the unit
When the unit is turned off, slide the HOLD/
switch of the
left side panel in the
direction, and when the
TASCAM
DR-44WL
(start-up screen) appears, release the switch.
The DR-44WL starts up and the Home screen is displayed.
Start-up screen Home screen
CAUTION
When turn the power on for the first time (or when the
built-in clock is reset due to no battery power), the
DATE/
TIME
screen will appear before the Home screen to set
date/time.