Brandmotion FDMC-1221 オーナーマニュアル

1221Instructions 11-04-14.doc

Page 1 of 5

2009 – Current F-150 flow though console models

Qi Wireless Charging Kit (Kit # FDMC-1221)

For use with Console Tray PN#(9L3Z-19A090-AA) and Mat PN#(9L3Z-1504G34-CB)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Needed:

Qi Wireless Charging Module with

F-150 Specific Mat

8’ Power Harness with 3 amp Fuse
4 – Flat Head Torx 1/2" Screws
These Instructions with Template
Removable Consumer Product Label

Plastic Trim Removal Tool

T-10 Torx Driver

Phillips Screw Driver
Center Punch/Scribe Tool
Power Drill
5/32”, 3/16” and 1/2” Drill Bits
Razor Knife

Soldering Iron & Solder

(Recommended)

Tape or Heat Shrink Electrical Tubing
82º Chamfer

*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit

www.brandmotion.com

for phone

compatibility guide.

Safety Precautions:

• Work in well ventilated area that is clear of obstructions.

• Secure vehicle with tire chucks in both front and rear of tires.

• Turn vehicle accessories OFF and ensure ignition key is in OFF position.

• Wear safety goggles and snug fitting clothes.

• Use tools only for their intended purpose and which are in good repair.

• Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions.

For additional assistance please call Brandmotion Technical Assistance at (734) 619-1250 then dial 2.

IMPORTANT: Do not place smart keys
within 15cm of charging mat. Vehicle
may not detect key to start vehicle. Do
not place metal objects in tray while
charging.