Dbx DriveRack 260 オーナーマニュアル

DriveRack

®

 

The EQ button 
toggles through
 the EQs used in 
each channel of 
the selected 
program 
menu. 

PEQ

GEQ

or

To edit the parameters of the EQs used in a selected program, simply use the following procedure. From program mode, 

press the EQ button to reach the EQ module to be edited.  Successive presses of the EQ button will move through each channel.  

Navigate  through the Pages of the selected EQ section by depressing "Next Page" or "Prev Page" successively until arriving at the desired Page.

GEQ  

On/Off

Flatten/Restore

   EQ

   EQ

Freq- 31.5Hz-18kHz

Gain  -12dB to12dB 

PEQ On/Off

Flatten/Restore

Bell,HSelf, LShelf, LHShelf, 

B1 Freq- 20Hz-20kHz

Gain  -12dB to12dB

Q .20 to 16.0

B2 Freq- 20Hz-20kHz

Gain  -12dB to12dB

Q .20 to 16.0

B2 Freq- 20Hz-20kHz

Gain  -12dB to12dB

Q .20 to 16.0

Successive presses of the Data wheel will select 
effect parameters within the currently selected page.

GEQ/PEQ

...

Freq- 19.7kHz to Out
Slope - BS, BW, LR
(6,12,18,24,36,48)

               

Low Pass

High Pass

Repeat, for each crossover band

XOVER

To edit the parameters of the Crossover used in a selected program, simply use the following procedure. From program mode, 

press the X-OVER button. Once you have reached the Crossover module, Navigate through the Pages of the selected Crossover

 module by pressing the "Next Page" or "Prev Page" buttons successively until arriving at the desired Page.

Gain- -20 to 20dB

        

Successive presses of the Data wheel will select 
effect parameters within the currently selected page.

XOVER

The XOVER button 
toggles through
the XOVER used in 
each channel of 
the selected 
program 
menu. 

Freq- 20.kHz to Out
Slope - BS, BW, LR
(6,12,18,24,36,48)

               

Section 2