ONKYO PR-RZ5100 オーナーマニュアル

Troubleshooting | Appendix

When you turn the unit on for the first time after purchasing 

it, Initial Setup is automatically shown on the TV to enable 

you to make settings required for startup using simple 

operations following onscreen guidance.

English
Deutsch
Français
Español
Italiano
Nederlands
Svenska

Exit

Initial Setup

Language Select

Operation:

Select the item with the cursors of the remote controller 

and press ENTER to confirm your selection. To return to 

the previous screen, press  .

To redo Initial Setup:

If you terminate the procedure on the way or want to 

change a setting made during Initial Setup, press   on the 

remote controller, select "7. Miscellaneous" - "Initial Setup", 

and press ENTER.

■ 1. AccuEQ Room Calibration

Place the supplied speaker setup microphone in the 

listening position, measure the test tones emitted by the 

speakers, then the unit automatically sets the optimum 

volume level for each speaker, the crossover frequencies, 

and the distance from the listening position. This also 

reduces the influence of standing waves to suit the 

listening environment, automatically adjusts the equalizers 

for the speakers, and enables correction of distortion 

caused by the acoustic environment of the room.

•  Calibration takes between 3 to 12 minutes to be 

completed. The speakers emit the test tone at high 

volume during measurement, so be careful of your 

surroundings. Keep the room as quiet as possible 

during measurement.

•  When using THX certified speakers, THX recommends 

setting the crossover frequency to "80Hz(THX)". It is 

also recommended to manually adjust the settings for 

each speaker to suit the specific characteristics of each 

room.

1.  Place the supplied speaker setup microphone in the 

listening position, and connect to the SETUP MIC jack 

on the main unit.

SETUP MIC

When putting the speaker setup microphone on a 

tripod, refer to the illustration when putting it in place.

•  To cancel AccuEQ Room Calibration partway 

through, disconnect the speaker setup microphone.

2.  Select the connected speaker configuration.

AccuEQ Room Calibration

Speaker Channels

Subwoofer
Height 1 Speaker
Height 2 Speaker
Bi-Amp

Select how many speakers you have.

Next

7.1.4 ch < >

       2ch
Top Front
Top Rear 
        No

The image on the screen changes as you choose the 

number of channels in "Speaker Channels", so refer to it 

when performing the settings. 

Also use this screen to select whether you have 

connected a subwoofer and to select the type of height 

speaker, etc.

•  If you have connected a subwoofer, check the power 

and volume of the subwoofer. Set the subwoofer 

volume to more than halfway.

3.  Test tones are emitted by the speakers, and firstly the 

unit detects the speakers connected and the noise in 

the environment.

4.  After the results of the above measurements are 

displayed, select "Next", press ENTER on the remote 

controller, and the test tones are emitted again, and the 

unit automatically makes settings such as the optimum 

volume level and the crossover frequency.

5.  Select whether to enable or disable the equalizer 

function that corrects for distortion caused by the 

acoustic environment of the room.

AccuEQ Room Calibration

On (All Channels)

On (Except Front Left / Right)
Off

To enable equalizer for each speakers, select "On".

Please select "All Channels", if you have same speakers for all 

channels. Please select "Except Front Left / Right", if front 

speakers are larger than other speakers. 

Next

If this is to be enabled, then normally you should